10
Installation
NOTE
• During the installation, Set A will not be operated by the remote
control after that. So, it is recommended to disable the remote control by KEY
LOCK, to avoid the operation by the remote control to being mixed up.
• After STACK MODE setting is completed, Set A (Sub) cannot receive the
remote control signal. When you set STACK MODE to OFF, enable the
remote control by KEY LOCK if necessary.
8. Disable the remote control by KEY LOCK if you use Intellectual Stack.
(Operating Guide → OPTION menu)
7. After pressing the ► button, a dialog to
conrm whether or not the setting is saved is
displayed.
Press the ► button to complete the setting. (
23
)
Installation of the rst projector (Set A) - Setting up Set A (continued)
6. Use the ▲/▼ buttons to point at STACK
MODE, and press the ► button to display
STACK MODE dialog.
Point at SUB pressing the ▲/▼ buttons, and
press the ► button.
To Next Page
Loading...
