Hitachi CP-X5021N - Setting up Set a

9
Installation
2. Set the lens position to upper limit with VERTICAL adjuster.
NOTE • If it is not set to upper limit, the image of Set B may not be able to
fully overlap to the image of Set A.
• If necessary, set MIRROR rst, since the setting change may shift the image
position. (

Operating Guide → SETUP menu)
• HORIZONTAL adjuster is recommended to be set around center position.
3. Adjust the image of Set A to match your screen with using VERTICAL adjust-
er, HORIZONTAL adjuster, ZOOM ring and FOCUS ring. (User’s Manual
(concise) → Displaying the picture)
If necessary, also use KEYSTONE and PERFECT FIT to set the image posi-
tion. (Operating Guide → EASY MENU or SETUP menu).
NOTE • ZOOM ring should not be set to fully wide position, otherwise the
image of Set B may not be able to fully overlap to the image of Set A. Be
aware that the image size of Set B must be set a little wider than the one of
Set A using ZOOM ring, since electrical ne tuning of image position of Set B
never widen the image size of Set B.
• When you use PERFECT FIT, KEYSTONE cannot be operated. If you
require to adjust the image with KEYSTONE and PERFECT FIT, adjust it with
KEYSTONE rst.
• If you use Simple Stack, go to Installation of the second projector (Set B).
(

11 )
(continued on next page)
Setting up Set A
1. Turn on Set A.
4. Display a menu with MENU button. (Operating Guide → Using the menu
function)
5. Using the ▲/▼/◄/► buttons, go down the menu tree as below.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION
> STACK
STACK menu will appear on screen.
(
Operating Guide → OPTION menu).