Hitachi CP-X5021N - Selecting Lamp Working Mode

19
Setting on Stack menu
3. Press the ◄ button to turn back to previous menu, or the ► button to com-
plete the setting. ( 23 )
NOTE • If DUAL is selected for the LAMP MODE, a menu to select MAIN or
SUB may be displayed on screen rst when a button on the control panel of the
projector or remote control is pressed. If displayed, select one of them which
you want to operate. Refer to some example below.
- When MENU button is pressed, a menu to select MAIN or SUB is displayed.
Then, if MAIN is selected, a menu either EASU MENU or ADVANCED MENU
on Main projector is displayed.
- When KEYSTONE button is pressed, a menu to select MAIN or SUB is
displayed. Then, if MAIN is selected, the KEYSTONE menu on Main projector
is displayed.
• When DUAL is selected for LAMP MODE, operating restrictions are as follows.
- AUTO POWER OFF and
FREEZE functions on both
projectors is disabled.
- The test patterns arranged
for CUSTOM of GAMMA and
COLOR TEMP are not displayed.
- It takes a little longer than
on other mode to turn on
the projectors, which is not
malfunction.

A menu to select
MAIN or SUB
A menu on Main

A menu to select
MAIN or SUB
A menu on Main
(continued on next page)
3.3 Selecting lamp working mode
Select one of lamp working mode, DUAL use or ALTERNATE use.
1. Point at LAMP MODE with the ▲/▼ buttons in
STACK menu, then press the ► button to display
LAMP MODE dialog.
2. Use the ▲/▼ buttons in the dialog to point at DUAL or ALTERNATE.
DUAL : for turning on the projectors at the same time.
ALTERNATE : for turning on the projectors alternately.