20
Setting on Stack menu
NOTE • When DUAL is selected for LAMP MODE, the following settings
are recommended because Main and Sub projectors may display different
images on screen.
- Set the same image on TEMPLATE and START UP functions on Main and
Sub projectors.
- Capture the same image on MyScreen on Main and Sub projectors.
- Save the same image on MY IMAGE on Main and Sub projectors.
- Set the same content of message for Messenger function (
Network Guide
→ Messenger Function) on Main and Sub projectors.
• When DUAL is selected for LAMP MODE, the image shift causes degradation
of image quality on screen. Set MIRROR setting in advance of image position
adjustment. When MIRROR setting (
Operating Guide → SETUP menu) is
changed, the image position is shifted.
• When ALTERNATE is selected, if an error is occurred and the lamp is turned
off on a working projector, the other automatically starts to work. In a case an
RS-232C cable is disconnected or AC power is not supplied, the other will not
work.
• Even when ALTERNATE is selected, if one or both of PIN LOCK and
TRANSITION DETECTOR are set to ON (
Operating Guide → SECURITY
menu), the both projectors will turn on. Then, after inputting security code for
each one, one of projector will turn off.
• In the Intellectual Stack use, POWER indicator on the control panel of
projector operates in different way from normal use. (
Operating Guide →
Troubleshooting) When Main and Sub projectors are in standby mode, if
STANDBY/ON button on the remote control or control panel of Main projector
is pressed, Main projector will decide projectors to turn on in accordance with
STACK MODE setting.
- While Main projector is selecting projectors to turn on, POWER indicator on
Main projector is blinking in green.
- If Main projector is required to turn on, POWER indicator on Main projector
turns to steady green after the lamp is on, as same as usual.
- If only Sub projector is required to turn on, POWER indicator on Main
projector turns to steady orange after Sub projector turns on.
- If an error is occurred on Main projector, Sub projector turns on and POWER
indicator on Main projector is lighting or blinking in red.
Selecting lamp working mode (continued)
To Next Page
Loading...
