Hitachi CP-X5021N - 4.2 Connecting signal cables

28
Connecting cables
Inputting image to Sub and Main individually
1.
Split output signal from your image device to two with a signal splitter or
something similar.
2.
Connect your image device to the same input port on Main and Sub
projectors.
NOTE for Simple Stack • As an input
port on the projector that is connected a
computer cable to the ports MONITOR OUT,
COMPUTER IN1 and IN2 that can be output
from MONITOR OUT port are available.
(

Operating Guide → SETUP menu) If you
wish to use other input port, input the image
to Sub and Main individually.
Inputting image to Sub from Main
1.
Connect the MONITOR OUT port on Main
to COMPUTER IN1 port on Sub with a
computer cable.
2.
Connect your image device to one of input
port on Main.
4.2 Connecting signal cables
There are two options to input image to Sub projector. (

22, 23 )
- Inputting image to Sub from the MONITOR OUT port on Main.
- Inputting image to Sub and Main individually.
NOTE for Intellectual Stack • As an
input port on Main projector in Intellectual
Stack, COMPUTER IN1 and IN2 are
available. Do not use other ports for image
input.
- If you wish to input a component signal,
input it to COMPUTER IN1 and IN2.
- If you wish to input a video signal, input it to
Y pin of component signal on COMPUTER
IN1 and IN2.
NOTE for Intellectual Stack • As an input port on Main projector in
Intellectual Stack, LAN, USB TYPE A and USB TYPE B cannot be used.
NOTE for Simple Stack • As an input port on the projectors, any input
ports which signal can be split to two are available.
Connection example
in Intellectual stack
Sub
Main