Hitachi CP-X5021N - For Simple Stack Users

16
Installation
NOTE
for all users • Refer to PERFECT FIT of EASY MENU or OPTION
menu in the Operating Guide for the detail of PERFECT FIT.
• Even if you place two projectors side by side (Style 2), adjust the image
position of one projector to the other's with the same way as explained above.
• It is strongly recommended to use a at screen. If you use a curved or
distorted screen, it is very difcult to adjust two images to be superimposed,
even if you use pin/barrel adjustment on PERFECT FIT.
• Even though you try to nely adjust the images from two projectors, it may
not be possible to superimpose the images depending on input signals. In this
case, try to resolve it with the following measures.
- Press AUTO button of the remote control or execute AUTO ADJUST
EXECUTE (

Operating Guide → IMAGE menu) on each of the projectors.
- Adjust H POSITION and V POSITION (

Operating Guide → IMAGE menu)
on each of the projectors.
- Check RESOLUTION setting on INPUT menu, and if it is different between
the two projectors, change the setting to the same. (

Operating Guide →
INPUT menu)
5. Using PERFECT FIT on Set B, adjust the im-
age size and position of Set B to fully superim-
pose to the image of Set A.
It is recommended to adjust it by the following
way.
(1) Adjust four corners roughly in turn as below.
Top left → Top right → Bottom right → Bottom left.
(2) Adjust four corners nely in turn as same as above.
For Simple Stack users
1. Press MENU button on the remote control to open a menu on Set A.
2. Use the ▲/▼/◄/► buttons to open
TEMPLATE dialog, then select STACK on
the dialog. (Operating Guide → SCREEN
menu)
3. Press MENU button on the control panel of Set
B to open a menu.
4. Use the ▲/▼/◄/► buttons to select
PERFECT FIT that is existed in EASY MENU
and OPTION menu of ADVANCED MENU.
(Operating Guide → EASY MENU or OP-
TION menu).
PERFECT FIT dialog appears on screen.
STACK of TEMPLATE
PERFECT FIT dialog
on STACK of TEMPLATE