Hitachi CP-X5021N - 3.5 Selecting input source to Sub

22
Setting on Stack menu
3. Press the ◄ button to turn back to previous menu, or the ► button to com-
plete the setting. ( 23 )
NOTE • If FIXED (COMPUTER IN 1) is selected, either COMPUTER IN
1 or IN 2 port can be selected as an input source on Main projector. When
COMPUTER or VIDEO button on the remote control or INPUT button on the
projector is pressed, MAIN INPUT SOURCE dialog will be displayed on screen.
Select COMPUTER IN 1 or IN 2 with the ▲/▼ buttons.
• If FIXED (COMPUTER IN 1) is selected, COMPUTER IN1 port on Sub
projector should be connected to MONITOR OUT port on Main projector with a
computer cable. The image that is input from the selected port is output from
MONITOR OUT port on Main projector and input to COMPUTER IN1 port on
Sub projector. The setting for MONITOR OUT on Main projector is invalid when
FIXED (COMPUTER IN 1) is selected. (

Operating Guide → SETUP menu)
• If FIXED (COMPUTER IN 1) is selected, video signals can be input to
COMPUTER IN1 and IN 2 ports on Main projector. Set the port which a video
signal is input to with COMPUTER IN, and set the video format on VIDEO
FORMAT. Refer to Inputting image to Sub from Main (

28 ) and Inputting
image to Sub from Main - Video signal (either COMPONENT or VIDEO) (

32 )
3.5 Selecting input source to Sub
1.
Point at SUB INPUT SOURCE with the ▲/▼ but-
tons in STACK menu, then press the ► button to
display SUB INPUT SOURCE dialog.
2. Use the ▲/▼ buttons in the dialog to point at FOLLOW MAIN UNIT or FIXED
(COMPUTER IN 1).
FOLLOW MAIN UNIT : for setting the input source on Sub projector as same
as the one on Main projector.
FIXED (COMPUTER IN 1) : for setting the input source on Sub projector to
COMPUTER IN1 port which is connected to MONITOR OUT port on Main
projector.