25
Setting on Stack menu
● The following functions are disabled.
- Executing of AUTO KEYSTONE (
Operating Guide → SETUP menu)
- STANDBY MODE (
Operating Guide → SETUP menu)
- AUTO SEARCH (
Operating Guide → OPTION menu)
- Turning on/off AUTO KEYSTONE (
Operating Guide → OPTION menu)
- DIRECT POWER ON (
Operating Guide → OPTION menu)
- MY SOURCE (
Operating Guide → OPTION menu)
- COMMUNICATION TYPE (
Operating Guide → OPTION menu → SERVICE
→ COMMUNICATION)
● The input source from the following ports cannot be selected.
- USB TYPE A, USB TYPE B, LAN
● An error message will be displayed if an error is occurred on projectors while
operating on Intellectual stack.
When an error is occurred, a full dialog will be
displayed on screen. After around 20 seconds
without any key input, the full dialog will be turned
to a small dialog. When a small dialog is displayed,
pressing the ◄ button displays a full dialog again.
A number on projector icon means that “1” indicates Main projector
and “2” does Sub.
Refer to a message on screen as shown below and take a necessary action to
solve the problem.
Example:
Cover Error: Lamp cover is opened.
Lamp Error: Lamp does not light up.
Fan Error: Cooling fan has a problem.
Temp Error: Temperature in projector is too
high.
Air Flow Error: Check exhaust vent that may
be blocked, since temperature in projectore is
too high.
Filter Error: Filter timer counts hours more than
the setting hours on Filter Message menu.
(
Operating Guide → OPTION menu →
SERVICE)
Cold Error: Air temperature around projector is
too low.
(continued on next page)
Important information for Intellectual Stack (continued)
Full dialog
Small dialog
To Next Page
Loading...
