35
Restriction on Schedule function
NOTE
• If the schedule is not executed, an alert message will be sent out in
any case in accordance with Schedule Execution Error setting on Web Control.
(
Network Guide → 3. Web Control → 3.6 Alert Settings).
• If the schedule function is set to turn off the power, Main and Sub projectors
will be turned off when the projectors are working in Intellectual Stack.
• If the schedule function on Main projector is set to turn on the power, the
projectors will start to work in accordance with LAMP MODE setting.
• When two projectors are working in DUAL mode, while a projector is
displaying some menu on screen the schedule function for My Image and
Messenger on the other projector will not be executed.
• Power Off in the chart means that the projector is turned off by settings on
Intellectual Stack or by STANDBY/ON button on the remote control or control
panel of Main projector, and is in standby mode.
• The projectors cannot be turned on by the schedule function on Sub projector.
Set it on Main projector if necessary.
• When Sub projector is turned off in ALTERNATE mode, the schedule function
on Sub projector to turn off Sub will be executed without an error.
Restriction on Schedule function (continued)
in Intellectual Stack. If input port is tried to change to any port that is allowed to
use on Intellectual Stack by schedule function the schedule will be executed, but if
not the schedule will not be done.
X *2): The schedule can put into Web Control even if the projector is working in
Intellectual Stack, but the schedule will not be executed.
X *3): The schedule setting cannot put into Web Control while the projector is
working in Intellectual Stack. The schedule will not be executed.
To Next Page
Loading...
