H2 – Automatic control indication
This function is used to display or hide the automatic control indication.
Setting condition Contents
00 Display
01 Hide
H3 – Operation mode change restriction
This function is used to configure restrictions to the operating mode.
Setting condition Contents
00 Operating mode change disabled (factory setting)
01 Operating mode set by the central control + FAN mode
02 Unlimited operating mode
H4 – Operation modes for the ventilation unit with energy / heat recovery
This function is only available for the ventilation unit with energy / heat recovery.
Setting condition
Contents
00 Air conditioning only
01 Ventilation only
02 Air conditioning + ventilation
H5 – Central control available after forced stoppage
This function allows for central control after the forced stoppage of the unit.
Setting condition
Contents
00 Not available
01 Available
6 Optional functions
218
SMGB0063 rev. 1 - 10/2010
To Next Page
Loading...
Need help?
General
