EasyManua.ls Logo

Hitachi F-7100 - Warranty on Product

Hitachi F-7100
121 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IMPORTANT - 3
Warranty on Product
The Hitachi F-7100 Fluorescence Spectrophotometer is warranted to be free
from defects in material or workmanship under normal use within the product
specifications indicated in this manual and under conditions given below.
This warranty is void if the instrument is not used in accordance with the
instruction manual.
(1) Scope of Warranty
Any parts that prove to be defective in design or workmanship during the
warranty period will be repaired without charge.
Note that a substitute part may be used for repair, or replacement with an
equivalent product may be made instead of repair. Such system
components as a personal computer and printer that are updated frequently
for improvement may not be available in original versions at the time of
replacement. If the instrument is discarded or resold without contacting us,
or if failures occur due to consumables or parts having a limited lifetime, such
will be excluded from the warranty.
(2) Warranty Period
One year from the date of initial installation.
(In case a separate warranty document has been issued, the warranty period
indicated in it takes precedence over the above period)
(3) Limitations and Exclusions on Warranty
Note that the following cases are excluded from the scope of this warranty,
i.e., these cases are beyond the coverage of free-of-charge repair even
during the warranty period indicated above.
(a) Failure due to operation at a place not meeting the installation
requirements specified by us.
(b) Failure due to use of power supply voltage/frequency other than
specified by us or due to abnormality in power supply.
(c) Corrosion or deterioration of the tubing due to impurities contained in
gas, air or cooling water supplied by the user.
(d) Corrosion of the electric circuits or deterioration of the optical elements
due to highly corrosive atmospheric gas.
(e) Failure due to use of hardware, software or spare parts other than
supplied by us.

Table of Contents