HITACHI Deskstar & CinemaStar 7K1000.B & Deskstar E7K1000 Hard Disk Drive specification
222
11.42.8 Error Reporting
The following table shows the values returned in the Status and Error Registers when specific error conditions
are encountered by a device.
A SMART FUNCTION SET command was received by the device without the
required key being loaded into the Cylinder High and Cylinder Low registers.
A SMART FUNCTION SET command was received by the device with a
subcommand value in the Features Register that is either invalid or not
supported by this device.
A SMART FUNCTION SET command subcommand other than SMART
ENABLE OPERATIONS was received by the device while the device was in a
―SMART disabled‖ state.
The device is unable to read its Attribute Values or Attribute Thresholds data
structure.
The device is unable to write to its Attribute Values data structure.
Table 163 SMART Error Codes
To Next Page
Loading...
