Need help?Do you have a question about the Hitachi HDS723020BLA642 and is the answer not in the manual?
Details the microprocessor, logic modules, and drivers controlling the drive's functions.
Specifies default logical drive parameters in Identify Device data for 1.5TB and 2TB models.
Defines command overhead and provides typical times for different command types.
Details seek time and latency, common to all models and seek modes.
Details connector location, signal definitions for SATA, and pre-charge specifications.
Outlines input voltage, power supply current, and ripple at the drive power connector.
Covers data integrity, cable noise, load/unload cycles, start/stop cycles, and power-off sequence.
Provides physical dimensions, mounting hole locations, connector positions, and drive mounting details.
Covers UL/CSA conformity, German safety mark, flammability, safe handling, RoHS, and circuit protection.
Contains status information similar to Status Register, without interrupt acknowledgement.
Holds the command code sent to the device; execution starts immediately after writing.
Controls device functions like software reset and interrupt enable.
Contains status from the last command or a diagnostic code.
Indicates the device status, updated on command completion or error.
Details responses to Power On Reset, COMRESET, and Soft Reset.
Describes Logical CHS and LBA addressing modes for data sectors.
Allows host to modify device behavior for reduced power consumption.
Provides self-monitoring, analysis, and reporting technology for device health.
Defines device modes: Locked, Unlocked, and Frozen.
Describes High level and Maximum level security settings.
Provides an example of setting up a protected area using LBA mode.
To Next Page
General