Hitachi hard disk drive specifications
200
11.38.6.3 Set Power Condition Timer subcommand
Command Block Output Registers
Command Block Input Registers
Power Condition IDs
Table 62
Timer(15:0)
If the new timer value is greater than the maximum value setting, then the device may set the value to the
maximum setting . If the new timer value is less than the minimum setting, then the device may set the value to
the minimum setting.
Timer Units
If the Timer Units bit is cleared to zero, then the Timer (15:0) shall be specified in units of 100 milliseconds. If the
Timer Units bit is set to one, then the Timer (15:0) shall be specified in units of 1 minute.
Table 138 Parameter