Swing louvre direction
1
Select the target group for the change of swing louvre direction at the “Monitor 1 (All Groups)” or “Monitor 2 (Block)”
screens. The screen with the settings for the selected group is displayed on the touchscreen.
Monitor 1 (All Groups) Monitor 2 (Block)
(1)
(1)
2
By tapping “
“ or “ ” of the “LOUVRE”, the swing louvre direction changes alternatively as shown below.
Angle range
Angle range
LCD
indication
COOL
DRY
HEAT
FAN
AUTO
: Auto swing operation is started.
3
Tap “Monitor screen” to return to the “Monitor” screen.
(2)(3)
NOTE
• When there are two or more groups registered in the same block, it is possible to change the target group for setting by tapping the
arrow buttons at the upper corners of the screen.
• In case that control mode is set as “Run/Stop Only”, setting changes affect all groups or all blocks.
It is not possible to change settings for each group.
• Depending on the type of air conditioner, the setting may not be possible or may be calibrated automatically.
• The louvre position displayed on the LCD and the actual louvre position do not always match during the auto swing operation.
• The actual swing louvre direction may not stop immediately after the switch is pressed.
5 Centralised remote controls
PSC-A32MN
TCGB0106 rev.0 - 12/2014
323
5
To Next Page
Loading...
