ENGLISH
9 DRAIN PIPING
9.1 DRAIN DISCHARGING BOSS
Model
Connecting procedure
1
portions.
2
3
4
? NOTE
• Do not use this drain boss set in a cold area, because the drain water
may freeze.
• This drain boss is not sufcient to collect all the drain water. If
collecting drain water is completely required, provide a drain-pan that
is bigger than the unit base and install it under the unit with drainage.
∅
10 ELECTRICAL WIRING
10.1 GENERAL CHECK
1
2
MODEL Z
max
RAS-2WHVRP -
RAS-2.5WHVRP -
RAS-3WHVRP
3
MODELS SITUATION REGARDING
IEC 61000-3-2 AND IEC 61000-3-12 Ssc “xx”
MODELS
RAS-2WHVRP
RAS-2.5WHVRP
RAS-3WHVRP
4
5
6
7
? NOTE
Check and test to ensure that if there is more than one source of power
supply, that all are turned OFF.
! CAUTION
• Check to ensure that screws for terminal block are tightly tightened.
• Check to ensure that the indoor fan and the outdoor fan have stopped
before electrical wiring work or periodical check is performed.
• Protect the wires, drain pipe, electrical parts, from rats or other small
animals. If not protected, rats may damage unprotected parts, and at
the worst, a re will occur.
• Wrap the accessory packing around the wires, and plug the wiring
connection hole with the seal material to protect the product from any
condensed water and insects.
• Tightly secure the wires with the cord clamp inside the indoor unit.
• Lead the wires through the knockout hole in the side cover when
using conduit.
• Secure the cable of the remote control switch with the cord clamp
inside the electrical box.
• Electrical wiring must comply with national and local codes. Contact
your local authority in regards to standards, rules, regulations, etc.
• Check that the ground wire is securely connected.
• Connect a fuse of specied capacity.
! DANGER
• Do not connect of adjust any wiring or connections unless the
main power switch is OFF.
• Check that the earth wire is securely connected, tagged and
locked in accordance with national and local codes.
PMML0509 rev.0 - 02/2019