Function No. Input Output
7 Demand current control 60% -
8 Demand current control 70% -
9 Demand current control 80% -
10 Demand current control 100% -
11 Low noise setting 1 -
12 Low noise setting 2 -
13 Low noise setting 3 -
0 No setting No setting
The same input/output function can not be set to different input/putput terminals.
If set, a setting of larger function number is became incalid.
“Func” (Function setting)
By pressing
the push-switches PSW3 (►) and PSW5 (◄), the setting can be changed. PSW4 (▼): forward, PSW2 (▲):
backward.
Fill out the selected function setting No. in the space of the table as shown (SET).
<Example>
Item SEG2 SEG1 SET
1 Circulator at Heating Function Thermo-OFF
FA 0
2 Night-Shift
ni 0
3 Cancellation of Outdoor Ambient Temperature Limit
GS 0
4 Defrost for Cold Area (Change of Defrost Condition)
Jo 0
5 SLo (Fan Speed) Defrost Setting
bJ 0
6 Cancellation of Hot Start
H 0
7 Priority Capacity Mode
nU 0
8 Compressor Frequency Control Target Value for Cooling
Hc 0
9 Compressor Frequency Control Target Value for Heating
Hh 0
10 Indoor Expansion Valve Control Target Value for Cooling
SC 0
11 Indoor Expansion Valve Control Target Value for Heating
SH 0
12 Not Prepared
Si 0
13 Not Prepared
So 0
14 Not Prepared
ci 0
15 Not Prepared
cb 0
16 Not Prepared
ch 0
17 Not Prepared
db 0
18 Demand
dE 0
19 Wave Function Setting
UE 0
20 Protection of Decrease in Outlet Temperature for Cooling
Fb 0
6 Optional functions
124
SMGB0065 rev. 1 - 12/2010
To Next Page
Loading...
