Hitachi RAS-8FSXN - 10 Servicing; Removing the Front Service Cover

10.1 Removing the front service cover
D A N G E R
• Turn OFF all the power source switches.
N O T E
• For servicing use the following tool:
- Phillips screw driver.
1 Remove the service cover -A-.
a Remove the six screws -C- from the service cover -A-.
b Hold
the
service cover -A- at the bottom and extract it
forwards.
2 Remove the front cover -B-
a Remove the four screws -C- from the front cover -B-,
starting at the bottom of the front cover -B-.
b Hold the front cover -B- at the top and lift it upwards.
Remove the right and left hooks that secure the front cover
-B- and extract the cover forward.
N O T E
1 When fitting
and removing the front cover take care not to
get injured with the edges of the cover.
2 When securing the front cover -A-, insert the hook -C-
firmly in the lower part of the square hole -D- of the side
cover -B-, as shown in the figure.
Do not insert the lower part of the front cover inside the
lower part of the base -E- .
A
B
C
A
B
C
D
E
10 Servicing
292
SMGB0065 rev. 1 - 12/2010