N O T E
In order
to carry out the prior check, in the case the wireless remote control is used, carry out the following
procedures:
1 Turn OFF the power supply.
2 Place contact no.1 of the wireless receiver's SW3 to the ON position.
3 Connect the PC-ART remote control to the terminal board.
4 Turn ON the power supply.
Once the check has been carried out, turn OFF the electrical power supply and return the connectors to the way
they were before the check.
TEMP
Press
(ex.)
Indication of
Unit No
.
"2"
CHECK
Press
RESET
ADDS. RN
Result
After 1 Second
After 1 to 5 Seconds
After
7 Seconds
from previous page
Repetition of Self-checking of Unit No. "1".
In case that there is a second unit.
<Self-checking Indication of the Next Unit>
Repetition
Release PCB
Check Mode
8 Troubleshooting
263
SMGB0065 rev. 1 - 12/2010
8
To Next Page
Loading...
