¿ Installation
Changing the location of electrical box
Depending on the installation space, changing the location of electrical box is available.
In case of changing the location of electrical box, follow the procedure below.
1 Remove the service cover for the electrical box.
2 Remove the service cover for the electronic expansion valve.
3 Remove the electric box.
4 Remove the wiring from the wire clip and edge saddle, and move the electrical box.
After
moving the electrical box, the wiring should be put into the edge saddle and bounded with the wire clip. (Refer to
“enlarged view of A” below.)
5 Mount the electrical box.
6 Rotate the service cover for the electronic expansion valve 180 degrees and mount it.
7 Mount the service cover for the electrical box.
D
B
C
(2)
(2)
(4)
(3)
(3)
(1)
(1)
(6)
(6)
A
(6)
(5)
(7)
(5)
(7)
A. See below the enlarged view.
B. Service cover for electrical box.
C. Electrical box.
D. Service cover for electronic expansion valve.
Enlarged view of A.
1
1
1
1
3
3
A
B
2
2
*
MVS2
MVS2
MVS1
MVS1
MVD1
MVD1
MVD2
MVD2
1 Edge sadle.
2 Wire clip.
3 Electrical box.
2 Unit installation
27
SMGB0065 rev. 1 - 12/2010
2
To Next Page
Loading...
