Hitachi RX2

●Start operation 3-2
3
Print description 2015.07.0712:45
M
Manual
Startup
Menu
Com=0
[Stop ]
Ink operating time １００(hours)
Cumulative op. time １００(hours)
Print count １０００(prints)
Ink pressure  ０．０００(MPa；standard value:０．２５０)
Change
message
Select
message
Overwrite
message
Adjustprint
parameters
Operation
management
Message name[ ]
− ＋
Current user ID : user2
Inter-
laced
Printcount
reset
●Confirm the print description, count value, and calendar character contents.
Press the Start switch. (Press for about 2 seconds.)
(Depending on the model, there may not be a Start switch. When the main power switch of 2 is
pressed, the following “Print description” screen appears.)
In the case of turning on the power again, ensure that status indicator lamp is off when Start switch is
pressed.
The “Print description” screen shown below appears.
If the “Select login user” screen opened, see “3.1.4 Specifying the user”.