(5) Inverter specifications (Extended function mode : C group)
Display Function name Category Screen display Initial Remarks
Order Code display EU US JPN
1 Input terminal 1 assign Set C01 00 00 00
2 Input terminal 2 assign Set C02 01 01 01
3 Input terminal 3 assign Set C03 02 16 02
4 Input terminal 4 assign Set C04 03 13 03
5 Input terminal 5 assign Set C05 18 09 09
6 Input terminal 6 assign Set C06 09 18 18
7 Input terminal 1 condition Set C11 00 00 00
8 Input terminal 2 condition Set C12 00 00 00
9 Input terminal 3 condition Set C13 00 00 00
10 Input terminal 4 condition Set C14 00 01 00 Note 1
11 Input terminal 5 condition Set C15 00 00 00
12 Input terminal 6 condition Set C16 00 00 00
13 Output terminal 11 assign Set C21 01 01 01
14 Output terminal 12 assign Set C22 00 00 00
15 FM terminal condition set C23 00 00 00
16 Function of AL terminal
setting
Set C24 05 05 05
17 Output terminal 11
condition
Set C31 00 00 00
18 Output terminal 12
condition
Set C32 00 00 00
19 AL output terminal
condition
Set C33 01 01 01
20 Level of overload signal Set C41 note note note Rated current of
each inverter
21 Arrival frequency
while acceleration
Set C42 0.0 0.0 0.0
22 Arrival frequency
while deceleration
Set C43 0.0 0.0 0.0
23 Level of deviation signal
under PID control
Set C44 3.0 3.0 3.0
24 Analog input O adjustment Set C81 -- -- --
25 Analog input OI adjustment Set C82 -- -- --
26 Debug mode selection Set C91 00 00 00
27 Core monitor address Set C92 0000 0000 0000
28 Core monitor data Set C93 -- -- --
29 Core set address Set C94 D0001 D000 D000
30 Core set data Set C95 -- -- --
Note 1
USP functi
on (NC) is allocated on US version and even another function such as CF1 is set, NO/NC
parameter is still the same. Therefore, please make sure the NO/NC parameter to suit the application.
1-5
To Next Page
Loading...
