Hitachi SJ300 Series

25
B022 Overload restriction setting Rated
current
x 1.50
B023 Deceleration rate at overload restriction 1.00
B024 Overload restriction operation mode (2)
•00Disabled
• 01 Enabled for accel and constant speed
• 02 Enabled for constant speed only
• 03 Enabled for accel, decel, constant speed
01
B025 Overload restriction setting (2) Rated
current
x 1.50
B026 Deceleration rate at overload restriction (2) 1.00
B031 Software lock mode selection
• 00 Low-level access, [SFT] blocks edits
• 01 Low-level access, [SFT] blocks edits
(except F001 and Multi-speed parameters)
• 02 No access to edits
• 03 No access to edits except F001 and Multi-
speed parameters
• 10 High-level access, including B031
01
B034 Run/power on warning time 0.
B035 Rotational direction restriction
• 00 Enable for both directions
• 01 Enable for forward only
• 02 Enable for reverse only
00
B036 Reduced voltage start selection
•00Short
• 01, 02, 03, 04, 05 (middle)
• 06 Long
06
B037 Function code display restriction
• 00 Display all
• 01 Display only utilized functions
• 02 Display user-selected functions only
(configure with U01 to U12)
00
B040 Torque limit selection
• 00 4-quadrant mode
• 01 Selected by 2 input terminals
• 02 From analog O2 input (0 to 200%)
• 03 From expansion card 1
• 04 From expansion card 2
00
B041 Torque limit (1) (forward-driving in
4-quadrant mode)
150.
B042 Torque limit (2) (reverse-regenerating in
4-quadrant mode)
150.
Func.
Code
Name / Description
Default
Val ue
–FE/FU/FR
Set
Val ue