Hitachi SJ300 Series

26
B043 Torque limit (3) (reverse-driving in
4-quadrant mode)
150.
B044 Torque limit (4) (forward-regenerating in
4-quadrant mode)
150.
B045 Torque limit LADSTOP enable
• 00 Disable • 01 Enable
00
B046 Reverse Run protection enable
• 00 Disable • 01 Enable
00
B050 Controlled deceleration and stop on power loss
• 00 Disable • 01 Enable
00
B051 DC bus voltage trigger level during power loss 0.0
B052 Over-voltage threshold during power loss 0.0
B053 Deceleration time setting during power loss 1.00
B054 Initial output frequency decrease during power
loss
0.00
B080 [AM] terminal analog meter adjustment 180
B081 [FM] terminal analog meter adjustment 60
B082 Start frequency adjustment 0.50
B083 Carrier frequency setting 5.0
B084 Initialization mode (parameters or trip history)
• 00 Trip history clear
• 01 Parameter initialization
• 02 Trip history clear and parameter initializa-
tion
00
B085 Country code for initialization
• 00 Japan version • 01 Europe version
• 02 US version • 03 (reserved)
01 / 02 / 00
B086 Frequency scaling conversion factor 1.0
B087 STOP key enable
• 00 Enable • 01 Disable
00
B088 Restart mode after FRS
• 00 Restart from 0Hz
• 01 Restart from frequency detected from
actual speed of motor
00
B090 Dynamic braking usage ratio 00
B091 Stop mode selection 00
B092 Cooling fan control
• 00 Fan always ON
• 01 Fan ON during Run, OFF during Stop
00
Func.
Code
Name / Description
Default
Value
–FE/FU/FR
Set
Value