Chapter 2 – Installation
Since the J300 series and the SJ300 series have different dimensions, you need to make
additional mounting holes or prepare an attachment plate when replacing.
Please refer to the following figures for the dimensional comparison.
2.1 In the case of making additional mounting holes
Please check beforehand that the existing wires for the J300 have enough length to be
connected to the terminals of the SJ300 because, depending on where the SJ300 is placed,
the wires may not reach the terminals.
[Unit: mm]
SJ300’s installation
dimension is in .
Figure 1
From J300-015-055L/H to SJ300-015-055L/H
SJ300’s installation
dimension is in
.
Figure 2
From J300-075L/H to SJ300-075L/H
3/24
To Next Page
Loading...
