Hitachi SPX-WKT2 - Display Alarm History; How to Display Alarm History; How to Clear the Alarm History

– 11 –
1.10 DISPLAY ALARM HISTORY
The history of failure modes are also stored in the nonvolatile memory of this remote controller. This function
is useful for when a failure to check whether or not occurred. (Time and date is also indicated.)
The remote controller can memorize to last 10 failure modes in the memory.
1.10.1 How to display alarm history
1 To enter the service menu.
2 Select "Display alarm history" from the service
menu and press "OK".
3 The last 10 failure modes (up to 5 failure modes
per one screen) in the memory will be displayed.
By pressing "
" or " ", scroll page.
4 Press " " (return/help) twice to return to
the normal mode.
1.10.2 How to clear the alarm history
1 Redisplay the alarm history. (Refer to section
"1.10.1")
2 Press "OK". The confi rmation screen is displayed.
Select "Yes" by pressing " " or " " and press
"OK".
3 Press " " (return/help) twice to return to
the normal
SPX-WKT2 11 8/15/16 11:33 AM