Hitachi SPX-WKT2 - Defrosting Inhibit Period Selection

– 12 –
1.11 DEFROSTING INHIBIT PERIOD SELECTION
The defrosting inhibit period selection can be changed.
This selection is valid with the single model only.
1 Turn the circuit breaker OFF.
2 Then turn the circuit breaker ON.
3 To enter the service menu.
4 Select "Defrost" from the service menu and press
"OK".
5 By pressing "
" or " ", the "Control Type" will
be changed as below.
"Default" "Changed"
6 Press "OK" to fi nish the defrosting inhibit period
selection setting. The confi rmation screen will be
displayed.
Default
Defrosting inhibit period
Average area setting
Cold area setting
(Average area setting period - 15 minutes)
Changed
7 Select "Yes" by pressing " " or " " and press
"OK".
The setting will be confi rmed and the screen will
return to the service menu.
8 Press "
" (return/help) to return to the
normal mode.
NOTE:
● The defrosting inhibit period selection setting will
remain unchanged after the unit is turned off.
SPX-WKT2 12 8/15/16 11:33 AM