Hitachi SPX-WKT2 - Fan Speed and Swing Control

– 7 –
1.6 INTERMITTENT FAN CONTROL
The intermittent fan control during thermo off in Heating mode mode can be changed.
1 Select "Intermittent fan Heat." from the service
menu and press "OK".
The intermittent fan control setting will be
displayed.
2 By pressing "
" or " ", the "Control Type" will
be changed as below.
".... No.1 No.2 No.3 No.1 ..."
3 Press "OK" to fi nish the intermittent fan control
setting. The confi rmation screen will be displayed.
30 sec ON/210 sec
OFF repeatedly
50 sec ON/190 sec
OFF repeatedly
Continuous
Continuous
30 sec ON/210 sec
OFF repeatedly
50 sec ON/190 sec
OFF repeatedly
Multi modelSingle model
No. 1
No. 2
No. 3
4 Select "Yes" by pressing " " or " " and press
"OK".
The setting will be confi rmed and the screen will
return to the service menu.
5 Press "
" (return/help) to return to the
normal mode.
NOTE:
● This setting cannot use during operation.
● The intermittent fan control setting will remain
unchanged after the unit is turned off.
SPX-WKT2 7 8/15/16 11:33 AM