●When a barcode of the same kind was set at adjacent print items, only the continuous series barcode is
assumed. However, fixed length barcodes such as EAN-13, EAN-8, UPC-A, UPC-E, EAN-13 Add-
On 5 and GS1 DataBar become independent barcodes.
●For multiple settings, provide a print item for which a barcode is not set between the print items with a
barcode set.
●Up to a maximum of 4 DM (Data Matrix), code 128, QR code, Micro QR and GS1 DataBar can be set
respectively.
● DotCode can be set up to 2.
●QR code and Micro QR can be collectively set up to 4.
●Since the number of horizontal dots is uniquely determined for barcodes, an inter-character space
cannot be set.
●A barcode can be set even for print items with a calendar and count set. However, when calendar
substitution, zero suppression, or an invalid character is set, for the barcode setting, the relevant
character is deleted.
●Neither the calendar nor the count set can be set to the country code.
●When code set C of code 128 was set when the English alphabet is set for the count upper limit, the
relevant character is deleted.
●Since start and stop codes are automatically generated, input as print description is unnecessary.
● When DM(16×16) or QR(21×21) is selected and when Bold is set to 2, IJ printer can print Cell size
(width and height) of 2 dots.
●A barcode with the identification numbers can be set in 1 line or 2 lines setting. When in 2 lines setting,
the barcode with the identification numbers can only be set to either upper or lower line.
●For GS1 DataBar, neither the calendar nor the count can be set to 1st, 2nd and 3rd digit.
●For ITF, the wide bar and space width can be set to horizontal 2 dots or 3 dots.
●In the case of NW-7, the space between each character is called the "character-to-character gap" and is
printed in the same size as the thin bar width (1 dot in width). However, the gap between characters of
NW-7 displayed on the screen is not limited to this, so the number of horizontal dots differs from the
actual printing.
●The barcode displayed on the screen is a guideline, so please check it by actual printing.
● Only UPC-A can be set at character size 30 × 40 and 36 × 48 print items. (Nozzle diameter 65μm)
To Next Page
Loading...
