Chapter 5 Creation and Setting of Print Messages
5-35
(b) [Repeat count]
● Sets the number of times repeat print is performed.
● If [Repeat print] is not needed, set the value to "0".
● Printing is performed according to the setting of [Repeat print] mode.
● The relationship between [Repeat print] mode and [Repeat count] is as follows:
Printing is performed specified
number of times in selected
interval while the print target is
detected.
Printing is performed repeatedly
in selected interval while the
print target is detected.
After the print target is detected
once, printing is performed
specified number of times in
selected interval.
After the print target is detected
once, printing is performed
repeatedly in selected interval
until the printing is stopped.
To Next Page
Loading...
