Hitachi UX2-D160W - Page 283

Chapter 12. When Warning or Fault Occurs
12-7
Chapter 12.
Fault message list (faults that stop the ink jet) (Continued)
Message
No.
Message
Message description
Solution
E-024
Ink Heating Unit
Over Current
The ink heating unit shorted out.
● Contact your nearest local
distributor.
E-025
Ambient
Temperature Sensor
Fault
The detection temperature of the ambient
temperature measurement is abnormal.
● Contact your nearest local
distributor.
E-026
Print Controller
Cooling Fan Fault
The cooling fan of the print controller
area is abnormal.
● Contact your nearest local
distributor.
E-031
Pump Motor Fault
The pump motor is abnormal.
● Contact your nearest local
distributor.
E-032
Inside Temperature
Sensor Fault
The detection temperature of the inside
temperature measurement is abnormal.
● Contact your nearest local
distributor.
E-034
Ink Heating Unit
Temperature Low
The ink heating unit temperature does not
rise above the correct operating
temperature.
● Contact your nearest local
distributor.
E-035
Model-key Fault
The model-key cannot be recognized.
● Contact your nearest local
distributor.
E-251
Circulation Route
Pressure Is High
The circulation route pressure is high.
● Contact your nearest local
distributor.