● Wear protective gear (goggles and mask) when checking the position of the ink stream.
● If any ink or makeup enters your eyes or mouth, immediately flush with warm or cold water and
consult a physician.
● Before ejecting the ink, make sure that there is no one in the ejection direction.
(Perform this operation with the end of the print head inserted in a beaker, etc.)
● Check the position of the ink stream from the sides and top of the print head as shown in the figure to
make sure that it is at the center of the gutter.
● If the ink stream is not at the center of the gutter, perform [No-cleaning stop] to stop the ink ejection.
Also, take action in accordance with the Technical Manual "6.4 How to correct ink stream bending
and nozzle clogging".
Install the print head cover and put the unit in the [Ready] state.
● If the screen status does not change from [Cover open] to [Standby], the print head cover may not be
appropriately installed. Install the print head cover again.
● See 3.1.3(2) Switching from [Standby] state to [Ready] state and put the unit in the [Ready] state.
● If the [Cover open] error is displayed, press Close.
Input the print target detection signal and check whether or not the printing state and print description are
correct.
● If the print target detection signal is input when the status is [Ready], the set print description is
printed.
To Next Page
Loading...
Need help?
General
