SAFETY
S-31
Prevent Fires
Check for Oil Leaks:
Fuel, hydraulic oil and lubricant leaks can lead to fires.
Check for oil leaks due to missing or loose clamps, kinked
hoses, lines or hoses that rub against each other, damage
to the oil cooler, and loose oil cooler flange bolts.
Tighten, repair or replace any missing, loose or damaged
clamps, lines, hoses, oil cooler and oil cooler flange bolts.
Do not bend or strike high-pressure lines.
Never install bent or damaged lines, pipes, or hoses.
Replace fuel hoses and hydraulic hoses periodically even
if there is no abnormality in their external appearance.
Check for Shorts:
Short circuits can cause fires.
Clean and tighten all electrical connections.
Check before each shift or after eight (8) to ten (10) hours
operation for loose, kinked, hardened or frayed electrical
cables and wires.
Check before each shift or after eight (8) to ten (10) hours
operation for missing or damaged terminal caps.
DO NOT OPERATE MACHINE if cable or wires are loose,
kinked, etc.
Never attempt to modify electric wirings.
SA-019
To Next Page
Loading...
Need help?
General
