Need help?Do you have a question about the Hitron HT-EMN2 and is the answer not in the manual?
This manual is intended for people who want to configure the HT-EMN2's features via its Graphical User Interface (GUI).
This manual contains information on each the HT-EMN2's GUI screens, and describes how to use its various features.
Quick Installation Guide: see this for information on getting your HT-EMN2 up and running right away.
For technical assistance or other customer support issues, please consult your Hitron representative.
Your HT-EMN2 is a Multimedia over Cable Alliance (MoCA) Ethernet-to-Cable Bridge (ECB) and wireless access point.
The HT-EMN2 provides MOCA 2.0, four Ethernet ports, dual-band Wi-Fi, TR-69, wireless security, and a secure configuration interface.
This section describes the HT-EMN2's physical ports and buttons.
This section describes the HT-EMN2's LEDs (lights).
Before logging into the GUI, your computer's IP address must be in the same subnet as the HT-EMN2.
Steps to log in to the HT-EMN2's GUI.
This section describes the HT-EMN2's GUI.
View summary of HT-EMN2 settings, turn auto sync, reboot, and factory reset.
Your HT-EMN2's wireless network is part of the Local Area Network (LAN), known as the Wireless LAN (WLAN).
The wireless network consists of two types of device: access points (APs) and clients.
Describes the IEEE 802.11 standards supported by the HT-EMN2 for wireless LANs.
Each wireless network is known as a Service Set, identified by a Service Set IDentifier (SSID).
Discusses wireless security protocols like WEP, WPA-PSK, and WPA2-PSK for authentication and encryption.
Explains WiFi-Protected Setup (WPS) methods: Push-Button Configuration (PBC) and PIN Configuration.
Allows temporary visitors to access the wireless connection without revealing the primary network password.
Explains Media Access Control (MAC) addresses as unique identifiers for network devices.
Allows setting up a list of devices by MAC address to deny or allow access to the wireless network.
Configure basic 2.4G wireless settings: turn wireless on/off, select mode and channel, and configure SSID.
Configure 2.4G wireless network authentication and encryption.
Manage your HT-EMN2's 2.4G WiFi Protected Setup (WPS).
Configure basic 5G wireless settings: turn wireless on/off, select mode and channel, and configure SSID.
Configure 5G wireless network authentication and encryption.
Manage your HT-EMN2's 5G WiFi Protected Setup (WPS).
Describes MoCA concepts and the Multimedia over Coax Alliance specifications for data delivery over coaxial cabling.
Explains MoCA devices use 'outlet-to-outlet' communications, considered 'horizontal' compared to traditional 'vertical' cable communications.
Illustrates how MoCA devices form a full 'mesh' or peer-to-peer network.
View general information about the HT-EMN2's MoCA-related settings.
View and make changes to the HT-EMN2's cable network settings.
Addresses the issue where none of the HT-EMN2's LEDs are lit, indicating no power or a device fault.
Troubleshooting steps when an LED on the HT-EMN2 does not behave as normal.
Steps to recover or find the HT-EMN2's default or current IP address.
Provides the default username and password for the HT-EMN2.
Troubleshooting steps for connectivity issues with the HT-EMN2 or internet access.
Guides on resolving issues when a wireless client cannot connect to the HT-EMN2.
To Next Page
General