TROUBLESHOOTING
Version 1.0, 04/2015. Copyright 2012 Hitron Technologies
48
Version 1.0, 04/2015. Copyright 2015 Hitron Technologies
48
Hitron HT-EMN2 User’s Guide
6
Troubleshooting
Use this section to solve common problems with the HT-EMN2 and your network. It
contains the following sections:
None of the LEDs Turn On on page 48
One of the LEDs does not Display as Expected on page 49
I Forgot the HT-EMN2’s IP Address on page 49
I Forgot the HT-EMN2’s Admin Username or Password on page 49
I Cannot Access the HT-EMN2 or the Internet on page 49
I Cannot Connect My Wireless Device on page 50
Problem: None of the LEDs Turn On
The HT-EMN2 is not receiving power, or there is a fault with the device.
1 Ensure that you are using the correct power adaptor.
Using a power adaptor other than the one that came with your HT-EMN2
can damage the HT-EMN2.
2 Ensure that the power adaptor is connected to the HT-EMN2 and the wall socket
(or other power source) correctly.
3 Ensure that the power source is functioning correctly. Replace any broken fuses
or reset any tripped circuit breakers.
4 Disconnect and re-connect the power adaptor to the power source and the HT-
EMN2.
To Next Page
Loading...
