Hive Thermostat Mini - 3 F. Stand-Alone Installations (Without Hub)

Hive Thermostat Mini Installation Guide
12
3f
Stand-alone installations (without Hub)
For Hive Active Heating a Hub, a Receiver and a thermostat are installed. When this service hasn’t
been bought, the thermostat and Receiver can also be installed without a Hub. This is known as
‘stand-alone’ mode.
Follow the steps in the next section if the thermostat and Receiver are to be installed without a Hub
in ‘stand-alone’ mode.
In ‘stand-alone’ mode the thermostat acts as a standard wireless thermostat without the remote
heating control features and functionality of Hive Heating. Whilst you can set target temperatures
on the Hive Mini and change mode, you cannot congure and edit schedules. This functionality
requires a Hub and app.
Activating stand-alone mode
1
Remove the batteries from the thermostat.
2
Switch o the boiler and Receiver.
3
Wait at least 5 seconds, then turn the boiler and Receiver back on.
The Receiver’s status light will begin to ash AMBER.
4
Press and hold the heating button for at least 10 seconds until the status light begins to ash
WHITE. The Receiver is now in ‘stand-alone’ mode and is searching for a thermostat.
5
Insert the batteries into the thermostat, press and hold down the Menu/Conrm and Down
arrow icons and follow the factory reset instructions on screen. After about 10 seconds,
‘Welcome to Hive Active Heating’ and ‘Searching…’ will be displayed on screen. If the thermostat
shows ‘Reconnecting’, then try steps 1 and 5 again.
To switch back to ‘Connected mode’
A. Switch the Hub o and then on again. If it begins to ash AMBER continue on to step B.
If all the lights go out and the Hub does not ash AMBER.
B. Press the button on the back of the Hub for 1 second. The Hub should now begin to ash AMBER.
C. Now follow steps 15 on page 12 but note that the lights will be dierent. At step 3 the Receiver’s
status light will initially ash WHITE/PINK and in step 4 it will change to AMBER (for Connected
mode) once you have held the Central heating button down.
D. At any time, you can check what mode the Receiver is set to by switching it o then on.
When power is restored, the status light will ash for 5 seconds, AMBER for Hive Active
Heating, WHITE for ‘stand-alone’ mode.