Hive Thermostat Mini - 3 G. Receiver Lights and What They Mean

Hive Thermostat Mini Installation Guide
13
3g
Receiver lights and what they mean
The Receiver has lights on its front panel to show what it’s doing.
A single channel Receiver has two lights, Status and Central heating. A dual channel Receiver has
an additional light for hot water. This is what the lights mean:
Light Colour Pattern Meaning Notes
Central
Heating
GREEN Solid Heating is on.
Central
Heating
GREEN Flashing Commands queued.
The Receiver has received
2 or more commands to
switch the boiler on or o
within 1 minute. Or, Heating
Boost mode with target
temperature lower than
room temperature.
The Hive Receiver protects
the boiler from damage
that may occur if it’s
switched on and o very
quickly. Once the boiler
has been switched on (or
o), it will not change state
again for 1 minute as a
protective measure.
Hot
Water
GREEN Solid Hot water is on. This light is only present
on dual channel Receivers.
Hot
Water
GREEN Flashing Commands queued.
The Receiver has received
2 or more commands to
switch the boiler on or o
within 1 minute.
See ‘Central heating’.
Status GREEN Solid Normal operation. The
Receiver is connected to
the rest of the Hive system
and operating normally.
Status BLUE Solid The system is in gravity-
fed mode and is connected
to the rest of the Hive
system.
See gravity-fed mode
section of this manual on
page 11. Gravity-fed mode
is only applicable to dual
channel Receivers.