Hive Thermostat Mini - Test the Boiler

Hive Thermostat Mini Installation Guide
15
4
Test the Boiler
After completing the wiring of the backplate, check that the boiler fires
with a demand from Hive:
1
Visually check the wiring to conrm that the connections have been carried out correctly.
2
For single channel Receivers, ensure that the switch position is in the correct operating mode
(if the switch is in the wrong position the boiler will not re up).
3
Conrm that the Receiver’s front panel is secured in place, and it is safe to commission the
boiler.
4
Restore power to the central heating system and test the boiler connection by pressing the
Central heating button. The central heating should come on and the boiler should re up.
For dual channel Receivers: do the same test for the hot water button.
5
When you are condent the connection between the Receiver and the boiler is working, press
the central heating button again to cancel the boiler demand.
6
After completing the test, leave the Receiver with the status light ashing AMBER,
(this means it’s ready to connect to the Hub and thermostat) and move on to stage 5.
For multizone systems, complete steps 1–5 for all Receivers.