Hive Thermostat Mini - Page 8

Hive Thermostat Mini Installation Guide
8
Now you’ve chosen the correct Receiver and found a suitable
location, mount the backplate as follows:
1
Loosen the screws on the underside of the Receiver
and remove the backplate by pulling the bottom of
it away from the front panel.
2
3
Fix the backplate to the wall with the
terminals at the top.
Run cable from the boiler or wiring centre
(if required), then continue to the next
section to wire up the backplate.
Note: if installing in OpenTherm mode
ensure you use separate cables for the
low/high voltage connections. These
should not share the same shrouding.
2
3