EasyManuals Logo

Hobart LEGACY HL300 User Manual

Hobart LEGACY HL300
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
– 16 –
TROUBLESHOOTING
Symptoms Possible Causes
Mixer will not start Flashing Time display - See Below
Branch circuit protector is in open position - check
fuse or disconnect switch.
Mixer is overloaded.
Wire cage is not in the closed position.
Bowl is not in closed (mix) position or bowl is not in
up position.
Agitator touches bowl Bowl is not in closed (mix) position.
Improper agitator clearance - see Maintenance for
adjustment procedure.
Agitator is not installed properly.
Planetary seal squeaks Seal requires occasional lubrication - see
Maintenance
Timerdisplaysashingalarmcode
(Ex. "OL1" - Motor overload)
Iftheerrorcodeisashing–unplugmachineuntil
display is blank then plug back in. If symptoms still
exist,contactyourlocalHobartServiceo󰀩ce.
SERVICE
Ifserviceisneededonthisequipment,contactyourlocalHobartServiceo󰀩ce@1-888-4HOBART.
F45233 Rev. A (November 2019) PRINTED IN U.S.A.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hobart LEGACY HL300 and is the answer not in the manual?

Hobart LEGACY HL300 Specifications

General IconGeneral
BrandHobart
ModelLEGACY HL300
CategoryMixer
LanguageEnglish

Related product manuals