EasyManuals Logo

Hobart LEGACY HL300 User Manual

Hobart LEGACY HL300
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
– 5 –
ELECTRICAL CONNECTIONS
The electrical cord on the HL300 (single-phase only) is equipped with a three-
pronged grounding plug which must be connected to a properly grounded receptacle. If
the receptacle is not the proper grounding type, contact an electrician. Do not remove the
grounding prong from the plug.
Electrical and grounding connections must comply with the applicable portion
of the National Electrical Code and/or other Local Electrical Codes.
Disconnect the electrical power to the machine and follow lockout / tagout
procedures.
For the three-phase HL300 and all HL400 mixers, a hole for the 3/4"-trade-size conduit is located at the
top of the pedestal. Make electrical connections per the wiring diagram located on the inside of the top
cover.
Single-Phase Mixer, HL400:
• ConnecteldsupplyleadwirestoL1andL2.
Connect ground wire to ground lug on the mixer.
Three-Phase Mixer, HL300 & HL400:
• ConnecteldsupplyleadwirestoL1,L2andL3.
Connect ground wire to ground lug on the mixer.
Check Initial Operation
1. Apply power to the mixer.
2. Turn the SPEED dial pointer to STIR.
3. Install the bowl and lock into mix position, with the Bowl Support all the way up and bowl guard
closed. Momentarily run the machine by pushing the START and then STOP buttons.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hobart LEGACY HL300 and is the answer not in the manual?

Hobart LEGACY HL300 Specifications

General IconGeneral
BrandHobart
ModelLEGACY HL300
CategoryMixer
LanguageEnglish

Related product manuals