EasyManuals Logo

Hobart Legacy HL600 User Manual

Hobart Legacy HL600
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
33
11.0 MIXER MAINTENANCE.
A HOBART TRAINED AND COMPETENT PERSON SHOULD CARRY OUT
SERVICING.
Do not remove any covers or loosen any fittings while the mixer is operating.
Ensure the electrical supply has been isolated before attempting to service or
move the mixer.
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND
FOLLOW LOCKOUT / TAGOUT PROCEDURES.
WARNING! THE ELECTRONIC DRIVE CONTROL IS FITTED WITH HIGH
VOLTAGE CAPACITORS. ISOLATE THE MIXER FROM THE MAINS AND ALLOW
THE CAPACITORS TO DISCHARGE FOR 5 MINUTES BEFORE REMOVING ANY
COVERS.
11.1 LUBRICATION
Figure 10.
11.1.1 SLIDEWAYS.
The slideways (Fig. 10) should be lubricated approximately twice a year. To reach
these areas, fully lower the bowl support and remove the apron, which is secured
by slotted screws. Wipe a thin coat of Lubriplate 630AA on the bowl pad area of
the bowl supports and on each slideway. Install the rear apron. Refer to the
recommended spare parts section for the Lubriplate oil part number.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hobart Legacy HL600 and is the answer not in the manual?

Hobart Legacy HL600 Specifications

General IconGeneral
BrandHobart
ModelLegacy HL600
CategoryMixer
LanguageEnglish

Related product manuals