30
Table 1. Technical information.
Description Units HL600 HL662
Motor power kW (hp) 2.0 (2.7) 2.0 (2.7)
Maximum speed of rotating part (50Hz) rpm 3975 3920
Nominal electrical supply 3 ph -- 400/50 400/50
Full load current at above voltage 3 ph -- 6.5 6.5
Locked rotor current at above voltage 3 ph Amps 16 16
Recommended fuse size 400v/3 ph/50Hz Amps 10 10
Minimum ambient temperature
o
C 0 0
Maximum ambient temperature
o
C 40 40
Transmission case lubricating oil capacity Litres 1.5 1.5
Attachment hub drive size -- # 12 # 12
Mixer weight (Bowl Included) Kg (Lbs) 411.4 (905) 411.4 (905)
Bowl weight (40 litre) Kg (Lbs) 15.9 (35.1) 15.9 (35.1)
Bowl weight (60 litre) Kg (Lbs) 18.8 (41.5) 18.8 (41.5)
Agitator weight (60 litre beater) Kg (Lbs) 2.8 (6.2) 2.8 (6.2)
Noise level dB (A)
Less than70
##
less than70
##
Shipping weight (Bowl included) kg (Lbs) 434.1 (955) 434.1 (955)
Shipping dimensions (carton) LxWxH
cm
118.75 x 81.6
x 169.86
118.75 x 81.6
x 169.86
Storage conditions. Temperature and
humidity.
o
C, +5 to +38, +5 to +38,
% RH 85 85
Class 1
#
Class 1
#
Class of appliance
Enclosure IP rating IP45 IP45
mm
2
Wiring terminal size; 3 phase 1.5/1.0 1.5/1.0
#
Refer to Section 10.3.
##
In accordance with EN-ISO 12001:1996.
10.1 UNPACKING AND HANDLING.
Wherever possible the food mixer should be transported to the
installation position in the packaging provided to avoid damage. Do
not use a sharp knife to cut into the box as damage to the machine
may occur. Check for possible shipping damage. If the unit is found to
be damaged, save the packaging material and contact your nearest
Hobart sales office.
Caution: The HL600 mixer is a heavy object and must be correctly handled
and lifted to avoid personal injury. Refer to Table 1, page 30 for weights and
dimensions. For UK installations refer to the ‘Manual Handling Operations
Regulations 1992 and HSE guidance notes for manual handling.
With the machine in the vicinity of its final position, remove from outer carton. Remove
mounting bolts under skid attached to mixer base. Remove mixer from skid forking from
the back of unit. When moving unit, always fork from back of unit.
To Next Page
Loading...
Need help?
General
