Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
122 Driving and Operating
Accessory power mode : press
Engine Start/Stop button once
without operating the brake pedal.
The yellow LED in the button
illuminates. Steering wheel lock is
released and some electrical
functions are operable, ignition
is off.
Ignition on power mode : press
and hold Engine Start/Stop button
for 6 seconds without operating
brake pedal. The green LED in the
button illuminates. Control indicators
light up and most electrical functions
are operable.
Engine start : press the brake
pedal and press the Engine Start/
Stop button once. Release button
after starting procedure begins.
Ignition off : press Engine Start/
Stop button briefly in each mode or
when engine is running. Some
functions remain active until the
driver ’s door is opened.
Steering wheel lock
The steering wheel lock activates
automatically when:
.
the vehicle is stationary and
.
the ignition has been switched
off and
.
the driver’s door is opened.
To release steering wheel lock,
open and close driver’s door and
switch on accessory mode or start
the engine directly.
{
Warning
If the vehicle battery is
discharged, the vehicle must not
be flat-towed or push started as
the steering wheel lock cannot be
disengaged.
Starting the Engine
Vehicles with ignition switch
Apply the park brake firmly.
Manual transmission : Press the
clutch pedal to the floor and move
the shift lever to the neutral position.
Automatic transmission : Move the
shift lever to the park or neutral
position.
Do not operate accelerator pedal.
To Next Page
Loading...
Need help?
General
