Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
74 Lighting
{
Warning
Always switch the headlamps to
low beam when vehicles are
approaching or when following
another vehicle.
To flash the high beam lamps:
1. Turn the ignition on.
2. Pull the lever towards the rear
of the vehicle and release.
The lights stay on for as long
as the lever is held.
Daytime Running
Lamps (DRL)
Daytime running lamps increase
visibility of the vehicle during
daylight.
They are switched on automatically
when the engine is running.
Hazard Warning Flashers
Press | to turn the hazard warning
flasher on or off, when the ignition is
in any position.
All turn signals flash continuously.
Use the hazard warning flasher if
the vehicle becomes a traffic
hazard, day or night.
Note
Using hazard warning flashers while
the vehicle is moving, is illegal in
some States and Countries.
Turn and Lane-Change
Signals
Push the lever in the direction the
steering wheel is turned.
A green arrow on the instrument
cluster flashes when the lamps are
in operation.
To Next Page
Loading...
Need help?
General
