Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
154 Vehicle Care
If the cooling system is cold, the
coolant level should be above the
line on the coolant reservoir.
Adding coolant
Caution
If the coolant level is too low,
engine damage may occur.
Do not spill coolant on the
vehicle's exterior surfaces as it
can damage the paintwork. If you
do, wash it off immediately.
Note
Use only approved coolant.
Recommended Fluids and
Lubricants 0 190.
1. Turn the ignition off.
2. Remove the coolant
reservoir cap.
3. Add the required amount of
coolant.
4. Replace the cap securely. If the
coolant requires regular
topping up, contact a Holden
Dealer.
{
Warning
Avoid repeated or prolonged
contact with coolant.
Wash off with soap and water.
Keep out of reach of children.
Washer Fluid
Check the fluid level weekly.
Adding washer fluid
1. Lift the front of the cap up.
Use the correct amount of
washer fluid additive. Refer to
a Holden Dealer.
Do not use ordinary soap or
detergent as they froth up and
damage the wiper rubbers.
2. Secure the cap.
To Next Page
Loading...
Need help?
General
