Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
Vehicle Care 163
2. Push the bulb into the socket
slightly and rotate
anticlockwise to remove.
3. Insert a new bulb.
4. Place the bulb into the socket
and rotate clockwise.
5. Replace the bulb holder and
rotate clockwise to engage.
6. Check lamp operation.
Taillamps, Turn Signal,
Stoplamps, and Reverse
lamps
1. Remove the two screws.
2. Remove the tail lamp
assembly.
Note
Make sure the cable duct remains in
position.
.
Tail lamp/brake lamp (1)
.
Turn signal lamp (2)
.
Reverse lamp (3)
3. Rotate the applicable bulb
holder anticlockwise.
To Next Page
Loading...
