Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
Vehicle Care 161
2. Disconnect the electrical
connector from the bulb holder.
3. Rotate the bulb holder
anticlockwise and remove from
the lamp.
4. Pull the bulb out of the bulb
holder.
5. Insert a new bulb into the
holder.
6. Reinstall the bulb holder into
the lamp and rotate it clockwise
until the centre of the bulb
holder is placed at the arrow
shape on the lamp.
7. Reconnect the electrical
connector and ensure the
locking pin is placed correctly.
8. Replace the two push nuts.
9. Check lamp operation.
To Next Page
Loading...
