HOLDEN MP SPARK User Manual

Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
Vehicle Care 175
{
Warning
Do not run the engine in an
enclosed area or with passengers
in the vehicle. Engine
Exhaust 0 125.
11. Place the compressor near the
tyre so that the sealant bottle is
upright.
12. Fit the sealant bottle into the
retainer on the compressor.
13. Unscrew the valve cap from
the defective tyre.
14. Screw the filler hose to the tyre
valve.
15. Press the switch on the
compressor to I.
The tyre fills with sealant.
The compressor pressure
gauge briefly indicates up to
88 psi / 600 kPa while the
sealant bottle is emptying
(approx. 30 seconds).
The pressure starts to drop.
Once the sealant is pumped
into the tyre, the tyre is inflated.
16. The tyre pressure
(approximately 33 psi /
230 kPa) should be obtained
within 10 minutes.
17. When the correct pressure is
obtained, switch off the
compressor.
{
Warning
Do not over-inflate tyres due to
risk of injury or damage to
the tyre.
18. If the tyre pressure is not
obtained within 10 minutes:
18.1. Remove the tyre
repair kit.
18.2. Move the vehicle one tyre
rotation.
18.3. Reattach the tyre repair
kit and continue the filling
procedure for 10 minutes.
Do not run the
compressor longer than
10 minutes.

HOLDEN MP SPARK Specifications

General

Brand	HOLDEN
Model	MP SPARK
Category	Automobile
Language	English