Stack’d Series HOMEGRID Technical
Page 3 Chapter 1: Safety Precautions
1.3. Transportation warnings
NOTE
：
●Batteries are tested according to UN Handbook of Tests and Criteria, part III, sub section 38.3
(ST/SG/AC.10/11/Rev.5).
●For transport the batteries belong to the category UN3480, Class 9, Packaging Group II and have to be
transported according to this regulation. This means that for land and sea transport (ADR, RID & IMDG)
they have to be packed according to packaging instruction P903 and for air transport (IATA) according to
packaging instruction P965. The original packaging complies with these instructions.
1.4. Disposal of lithium batteries
1.5. Before Connecting
◆After unpacking, please check product and packing list first, if product is damaged or lack of
parts, please contact your distributor.
◆Before installation, be sure to turn off the grid power and make sure the battery is in off mode.
◆Wiring must be correct, do not reverse the positive and negative cables, also ensure no short
circuits with the external device.
◆DO NOT connect the battery and AC power directly.
◆The embedded BMS in the battery is designed for 48V DC, DO NOT connect battery in
series.
◆ Battery system must be well grounded, and the resistance must be less than 1oumu;
◆Make sure the grounding connection set correctly before operation.
The battery must be transported in its original or equivalent package and in an upright
position. If the battery is in its package, use soft slings to avoid damage.
Do not stand below a battery when it is hoisted.
Never lift the battery at the terminals or the BMS communication cables, only lift the
battery at the handles.
Batteries marked with the recycling symbol must be processed via a recognized
recycling agency. By agreement, they may be returned to the manufacturer.
Batteries must not be mixed with domestic or industrial waste.
Do not throw a battery into fire.
To Next Page
Loading...
